Welcome to the State Water Resources Control Board Welcome to the California Environmental Protection Agency
Governor's Website Visit the Water Board Members Page
Agendas
My Water Quality
Performance Report
UST Program - LG 113

UST Programs - LG 113

Issue Date: April 18, 1997
Revision Date: November 6, 1997
 

ProTank, Inc.

LTH-5000 Line Tester

LINE TIGHTNESS TEST METHOD

Certification Leak rate of 0.1 gph with PD = 99.8% and PFA = 1.3%.
Leak Threshold 0.05 gph. 
A pipeline system should not be declared tight if the test result indicates a loss that equals or exceeds this threshold.
Applicability Gasoline, diesel, aviation fuel, fuel oil #4. 
Other liquids may be tested after consultation with the manufacturer.
Specification System tests fiberglass and steel pipelines. 
Tests are conducted at 150% operating pressure. 
Mechanical line leak detector must be removed from pipeline for duration of test.
Pipeline Capacity Maximum of 40 gallons.
Waiting Time None between delivery and testing. 
Minimum of 1 hour between dispensing and testing.
Test Period Minimum of 10 minutes. 
Repeat 10 minute cycles are necessary if data does not meet the manufacturer's criteria. 
Test data are acquired and recorded manually. 
Manual calculations are performed by operator on site.
Calibration Sensors must be calibrated in accordance with manufacturer's instructions before each test.

 

ProTank, Inc.

Evaluator:  Midwest Research Institute

3545 Lomita Blvd., Suite G

Tel:  (816) 753-7600

Torrance, CA  90505

Date of Evaluation:  02/14/91

Tel:  (800) 438-1111

 

 | Home | Vendors: A - F | Vendors: G - M | Vendors: N - S | Vendors: T - Z | Method Index |

Appearance on this list is not to be construed as an endorsement by any regulatory agency nor is it any guarantee of the performance of the method or equipment.
Equipment should be installed and operated in accordance with all applicable laws and regulations.
For full details, please refer to our expanded "DISCLAIMER" page.

 
 

.