Welcome to the State Water Resources Control Board Welcome to the California Environmental Protection Agency
Governor's Website Visit the Water Board Members Page
Agendas
My Water Quality
Performance Report
UST Program - LG 113

UST Program - LG 113

Issue Date: October 4, 2007

CGRS, Inc.

iota® VaporTite - V005

NON-VOLUMETRIC TANK TIGHTNESS TEST METHOD (TRACER)

Certification Leak rate of 0.005 gph as vapor with PD = 100% and PFA = 0%.
Leak Threshold A tank system should not be declared tight when the change in helium concentration in the interstitial space over time exceeds the method's preset threshold.
Applicability Method tests under pressure the primary containment of secondarily contained tanks, piping and other components. The primary and secondary components of the system under test must be dry, containing no liquid.
Tank Capacity Not limited by capacity.
Test Period Minimum 10 minutes for piping and 20 minutes for tanks. Test period varies in accordance with iota® software and test procedures, and is a function of several factors, including interstitial volume, flow rate, diffusion rate, and the concentration of helium in the component being tested.
Waiting Time No waiting period is required between adding helium to the primary containment and starting the test.
Dosage Helium dosage varies depending on the component being tested. In all cases, 100% industrial helium is used as prescribed in the manufacturer's test procedures.
Sampling Points Sampling is performed by circulating air through the interstitial space between the primary and secondary walls of the component(s) being tested and measuring the He levels in the circulated air.
Groundwater Groundwater level is not determined and does not impact the test. Flow meter is used to verify that the interstitial space is dry and has sufficient air movement.
Detector Helium is measured by the helium detector, which supplies data to the iota® system for analysis and pass/fail determination. Third-party evaluation was conducted using the Varian models PHD-04 and 979 detectors, but evaluator indicates that any helium detector meeting at least the following performance standards can be used:
  Minimum Detectable Concentration
Smallest Detectable Leak
Response Time
Background Suppression
2 ppm
5 x 10-6 atm-cc/sec
< 2 seconds
Automatic
Calibration Helium detector performs an auto calibration on start up and must be checked monthly and, if necessary, calibrated in accordance with manufacturer's instructions.
Comments

This method is intended primarily for use on new installations before product has been added to the system.
The interstitial volume of the components being tested must be entered manually, or the iota® software can calculate volume based on piping type/length or sump dimensions entered by the tester.
Third-party evaluation included tests to show that the method can find leaks on a variety of UST system components, including double-wall piping, double-wall USTs, and primary components contained within tanktop/under dispenser sumps.
This method is only able to test double-walled tanks that have 2 interstitial access ports on opposite ends of the tank and have a dry primary and interstitial space.
The method was evaluated on a 32 foot long tank with access ports spaced 28 feet apart. 
The method cannot be used to satisfy the requirement for ELD testing of existing UST systems that are located within 1000 feet of a drinking water well.

 

CGRS, Inc..

Evaluator:  Ken Wilcox Associates

1301 Academy Court

Tel:  (816) 443-2494

Fort Collins, CO 80524

Date of Evaluation:  07/25/07

Tel: (800) 288-2657

 

E-mail: info@iotaleakdetection.com

URL: www.iotaleakdetection.com  

 | Home | Vendors: A - F | Vendors: G - M | Vendors: N - S | Vendors: T - Z | Method Index |

Appearance on this list is not to be construed as an endorsement by any regulatory agency nor is it any guarantee of the performance of the method or equipment.
Equipment should be installed and operated in accordance with all applicable laws and regulations.
For full details, please refer to our expanded "DISCLAIMER" page.

 
 

.