Issue Date: November 22,
1995
Revision Date: September 11, 1998
INCON
Intelligent Controls, Inc.
TS
2000
(Magnetostrictive Probe)
AUTOMATIC
TANK GAUGING METHOD
|
Certification
|
Leak
rate of 0.2 gph with PD = 99.9% and PFA = 0.5%.
|
|
Leak
Threshold
|
0.058
gph.
A tank system should not be declared tight if the test
result indicates a loss or gain that equals or exceeds
this threshold.
|
|
Applicability
|
Gasoline,
diesel, aviation fuel, fuel oil #4.
Other liquids with known coefficients of expansion and
density may be tested after consultation with the manufacturer.
|
|
Tank
Capacity
|
Maximum
of 15,000 gallons.
Tank must be between 50 and 95% full.
|
|
Waiting
Time
|
Minimum
of 6 hours between delivery and testing. Minimum of 2
hours between dispensing and testing.
There must be no delivery during waiting time.
|
|
Test
Period
|
Minimum
of 3 hours.
Test data are acquired and recorded by system's computer.
Leak rate is calculated from data determined to be valid
by statistical analysis.
There must be no dispensing or delivery during test.
|
|
Temperature
|
Average
for product is determined by a minimum of 5 resistance
temperature detectors (RTDs).
|
|
Water
Sensor
|
Must
be used to detect water ingress.
Minimum detectable water level in the tank is 1.04 inches.
Minimum detectable water level change is 0.011 inch.
|
|
Calibration
|
RTDs
and probe must be checked and, if necessary, calibrated
in accordance with manufacturer's instructions.
|
|
Comments
|
Not
evaluated using manifolded tank systems. Therefore,
this certification is only applicable when there is
a probe used in each tank and the siphon is broken during
testing.
Tests only portion of tank containing product.
As product level is lowered, leak rate in a leaking
tank decreases (due to lower head pressure).
Consistent testing at low levels could allow a leak
to remain undetected.
EPA leak detection regulations require testing of the
portion of the tank system which routinely contains
product. TS 2000 can support up to 4 tanks.
California regulations
require at least one test per month after routine product
delivery or when the tank is filled to within 10% of
the highest operating level of previous month.
|
