Issue Date: May 27, 2004
Revision Date: June 10, 2004

SGB (Sicherungsgeratebau GmbH)

Overpressure Leak Detection System Model DLR-G

Continuous Interstitial Line Monitoring Method (Pressure/Vacuum)

Certification Certified per European leak detection standard EN 13160-2, Part 2, as a Class I leak detection system.
Operating Principle System uses pressurized nitrogen gas to continuously maintain an overpressure within the interstitial space of double-walled piping. System is designed to activate a visual and acoustic alarm before stored product can escape to the environment. System is capable of detecting breaches in both the inner and outer walls of double-walled piping.
Alarm Condition System alarms when a leak occurs which causes the pressure within the interstitial space to decrease to the “Minimum Interstitial Space Alarm Pressure” (see table below).
Applicability

Double-walled piping, underground or aboveground, having a design strength capable of safely sustaining the required operating pressure in the interstitial space. Piping may convey flammable, combustible, or non-combustible liquids including gasoline, gasohol, diesel, heating oil #2, kerosene, aviation fuel, motor oil, and acidic or caustic solutions.

Note: Conveyed product must not react with pressurized nitrogen. Interstitial space to be monitored must not exceed 150 ft3.
Manufacturer's Specifications

The leak detector can be configured to monitor primary lines with operating pressures up to 120 psi, as indicated in the following table. The interstitial space shall be rated for the operating pressure (interstitial space refilling "off" pressure) of the leak detector, as indicated in the following table. Pressures shall be set as follows:

Maximum Primary Line Pressure (psi) Minimum Interstitial Space Alarm Pressure (psi) Maximum Intersitial Space Refilling "Off" Pressure (psi)
Unpressurized 15 30
15 30 45
30 45 60
45 60 75
60 75 90
75 90 105
90 105 120
105 120 135
120 135 150

The DLR-G leak detector is not explosion protected. Do not install in a volatile, combustible or explosive atmosphere. Install the detector inside the building in a dry, frost-proof area. When using nitrogen gas, ensure that the room is ventilated according to applicable codes due to asphyxiation hazard. If installed outside in a protected area, place in a weatherproof protection box with a transparent lid.
Calibration Functional and operational safety tests must be performed annually in accordance with manufacturer's instructions.
Comments Interstitial space is tested continuously.
System can operate in two modes: with or without a nitrogen bottle continuously connected. Nitrogen bottle must be connected unless the piping is "impermeable" (e.g., double-walled steel).
Pressure is generated by inert gas bottle (nitrogen) and is measured and controlled by a pressure switch.
This system may not be compatible with all secondarily contained tanks and/or piping. Always consult with the tank and/or piping manufacturer and the manufacturer's applicable recommended installation practices before installing this system, or damage may be caused to the tank or piping by its use.
  • SGB (Sicherungsgeratebau GmbH)
    Hofstrabe 10
    57076 Siegen, Germany
    Tel: +49/ (0) 271 / 48964-0
    Email: Sgb-mail@t-online.de
  • Evaluator: TUV (Technischer Uberwachungs-Verein Nord e.V.)
    Date of Evaluation: 01/27/04

Home |  Vendors: A–F |  Vendors: G–M |  Vendors: N–S |  Vendors: T–Z |  Method Index

Appearance on this list is not to be construed as an endorsement by any regulatory agency nor is it any guarantee of the performance of the method or equipment. Equipment should be installed and operated in accordance with all applicable laws and regulations. For full details, please refer to our expanded DISCLAIMER page.